Some progress... The backpanel is pretty much 95% ready, needs just few holes and finishing touch, going to wetsand it but I'm not going to use too fine paper, I don't want it to shine too much.

Propably makin' the front panel tomorrow and cut new heatsink for power supply's regulators (The first try went to disaster when the M3-thread tap snapped on two different pieces while making the last threading to the heatsink - damn what a lucky shot, spent propably 5hrs to try get it off, in the end I decided to just make a new heatsink as they are not so expensive shiznit...)

Propably going to buy small table drill-press too. Any good suggestions?