.:Info
Nick: alfons  Info
Age: 27
Location: Kerava

.:Projects by user

.:Albums

.:



Title: experimental laser
Created: 26.03.2011 17:10
Experimental Full case made from scratch. Full steel. Bitumen inside.

I realized that bitumen is not the
Ready.
Painted with black "hammer varnish" which turned out pretty nice. Also painted with clear/dim varnish.
Ready.
Handles
Handles
Ready.

Backside
Ready.
Power Button
Power Button...
Bitumen installed. "4mm RS-bitumi 7,5kg/m2". I used around 6kg 

Overall weight is around 16kg + hardware.
Bitumen installed. &...
Power Button
Power Button...
I added nice extra IKEA handles, which are also really practical. It aint LAN case. Still lacking SuperB finishing ideas.
I added nice extra I...
Dust filter. I dunno is the fabric the best choice. Perhaps little too dense. Surface area is 450cm2, and it covers two 12cm fans (2x100cm2)
Dust filter. I dunno...
Setup inside.

PSU is screwed to "backpanel". Though backpanel or MOB's backpanel are not yet attached anywhere.

Because backpanel is only fully open side, it is _bit_ more tricky to assembly components inside.
"Fortunately" I dont replace my components every week or month.

Also bitumen and acoustic foam/fabric will be installed inside.

All the hot air is coming from that upper gap. I wonder does it need any mesh or something...
Setup inside....
Setup inside.

Because backpanel is only fully open side, it is _bit_ more tricky to assembly components inside.
"Fortunately" I dont replace my components every week or month.

Also bitumen and acoustic foam/fabric will be installed inside.
Setup inside....
Two HDD bolted together with 3mm thick alu sheet. Also "legs" attached. I figured that legs because nothing else came mind. 
Vibration covers still missing
Two HDD bolted toget...
I glued 4mm steel braces with epox. Also airtight seams are glued with epox. Also MOB slides are glued.

I would weld them but had no time.
I glued 4mm steel br...
Bottom frame, 4mm steel. Wooden legs are 38mm tall. Dust filters are coming to that 38mm wide gap.
Bottom frame, 4mm st...
Back panel from old "functional (not) case" 

Left hole is for 120mm PSU and the right one is for 120mm chassis fan
Back panel from old ...
I got like 1-2h to make this body ready. Got too hurry. 
Size is 345mm x 350mm x 310 + 40mm (Width, Depth, Height)
I got like 1-2h to m...
Ruukki laser. 2mm thick steel
Ruukki laser. 2mm th...