.:Info
Nick: crayonbox  Info
Age: 49

.:Albums

.:



Title: Ergo Arms Clean Up
Created: 09.08.2017 06:31
Adding a PVC Pipe to clear up the clutters of all the wiring running in the back of my monitor to Gaming Rig
More Up Close shot. I used a Dremel to cut and sand down smoothly.
More Up Close shot. ...
This is the route I decided to go for.
This is the route I ...
As you can see it has a nice round bend to it. It matches my ERGO arms perfectly! 

You can see the drawing on the PVC pipes. I was planning on using Dremel to cut from one end to other then I decided not. I was afraid it would have weaken the PIPE to bend  easily. 

You will see in next Image what I did...
As you can see it ha...
I bought a 10 foot PVC PIPE. I also used duct tape on the end of the PVC pipes. I add the sand inside the PVC pipes. I filled it up and taped it off with duct tape again. 

Then I had to tape and roped one end of the PVC pipe to my ergo curved bar. I then asked my wife to help with the heat gun heating the PVC pipes while I bend it little by little to get the result I wanted. 

It was a headache I tell you. It wouldn't budge at first so I turned up the heat then finally I could feel the nice bend to start happening.
I bought a 10 foot P...
All the wiring clutters! UGH..
All the wiring clutt...

Title: Gaming Rig
Created: 27.02.2015 16:10
The Ultimate Gaming Rig!
Now Mounted the Power Supply by Corsair
Now Mounted the Powe...
Another problem with Mounting the Cooler Master Fans on top fan rack. I had to drill the holes bigger.
Another problem with...
Now the fan mounted easily! It also covers the top part of the screw. Nice and Clean looking!
Now the fan mounted ...
Top Part Fan Shroud modded as well.
Top Part Fan Shroud ...
So the Fan Shroud were cut off as shown. This allowed the fan with screws sticking out fit in better. It would also clamp well!
So the Fan Shroud we...
Another problem! The screw on cooler master was sticking out on the shroud and would not clamp on. Another simple modding needed!
Another problem! The...
Voila the sticking out piece is gone! Had it cut or sliced off with a good sharp knife.
Voila the sticking o...
The Cpu Fan Mounted Part wouldn' lay flat on Cooler Master
The Cpu Fan Mounted ...
Cpu Fan Mount part not fit Cooler Master Fans! So simple Modding is needed!
Cpu Fan Mount part n...
Getting the Rig Naked...
Getting the Rig Nake...
Here are the specs or the goodies that's going in the CaseLabs... Just need to get few things like plug for the fans. They run two pin so Need to get em pluged into 4. I want em in color black, not those white ends which will look crappy.. Once I get em then I'll be ready to put em together..
Here are the specs o...
The CASELABS gaming rig!
The CASELABS gaming ...

Title: Gaming Desk
Created: 27.05.2013 20:01
This is where I'll set up to do some gaming on plus some Multi-media stuffs...
Finished product. The only thing left to do is adding double ergo arms.
Finished product. Th...
Added the 2nd desktop piece. This is where my ergo arms to hold 3 LCD is gonna be mounted. It will not be clamped but grommet mounted instead...
Added the 2nd deskto...
Added sliding drawer for keyboard to the executive desk I bought from junkyard!
Added sliding drawer...